A door hanging outside its track can fall; we brace it, work out what pushed it out and guide it back in.
A garage door that has come off its track should not be run again until it is secured, because an off-track door is an unsupported weight that can fall. Usually one or more rollers have popped out of the vertical or horizontal rail. The door then hangs crooked in the opening, binds against the jamb and can twist the sections as the opener keeps pulling.
Resist the urge to press the button again or to force the door. Driving an off-track door strips opener gears, bends the track and can crack a section. Our first step is to block and support the door, release the tension in a controlled way, and disconnect the opener. Then we find what pushed it off: a broken cable, a bent rail, a loose bracket, a dried roller that seized, or an impact.
Only then do we re-seat each roller, straighten or replace the damaged track, replace the failed part and restore balance. If a section is bent, we recommend replacing it before it takes the rest of the door with it. We cycle the door several times and confirm the reversing system before we leave.
Cold mornings are when we see many doors leave the track. A frozen bottom seal can hold one side down while the opener pulls the other up, and a sheet of ice in the lower track stops a roller dead. At roughly 102 days a year with a low at or below freezing at the Dulles airport station, a stuck, lopsided door on a cold morning is a pattern we know.
The second cause is the parking itself. Tight driveways and shared courts produce bumper strikes on the lower rail. A rail pushed a quarter inch out of plumb may still work for weeks before a roller finally climbs out. We trace which one it was, so the repair holds.
The door is blocked and supported, the opener disconnected and any stored spring tension controlled before anything else moves.
Cables, brackets, rollers, rails and sections are examined to see what pushed the door off its track.
Rollers are guided back in, damaged track or sections are replaced, and the price is quoted on site before work starts.
The balance is reset, the door cycled by hand and by opener, and the reversing system verified.



Tell us in a line what the door does — stalls halfway, slams down, hums without moving, sits crooked — and the Westwood office calls you back to fix a time. Starting prices sit on every service page; your own number is worked out at the garage.
Fill in the short form ☎ Call (571) 380-8377
The way we treat the details you type in is described in our privacy notice.