We take measurements of the opening, help you choose a style for the house, then fit, balance and seal the new door.
A new garage door installation replaces the door, the tracks, the springs and the seals as one matched system, sized to the opening it goes into. Industry guidance warns against hanging a new door on the old track, because section thickness, door weight, headroom and opener position all affect which track and spring set will work. We measure the width, height, headroom, side room and back room before we recommend anything.
Insulation is the big choice. One manufacturer's buying guide describes insulated doors as a layer of polystyrene or polyurethane foam between two steel skins, with R-values running from about R-6 to R-20, and a non-insulated door sitting near zero. Polyurethane is denser and rates higher, polystyrene is the lighter-weight, lower-cost option. An attached garage with a room above is where the extra R-value and quieter operation pay back most.
The crew removes the old door and hardware, installs the new sections with hinges and rollers, hangs new torsion springs sized to the final weight, fits weatherstripping, reinforces the top section for the opener, and balances the door before it is connected. You get the exact price on site before any work starts.
A cold-weather climate rewards insulation. The Dulles airport station records a low at or below freezing on about 102 days a year and a high at or above 90 degrees on about 33, and a garage built into the house passes those swings to the rooms next to it. An insulated door with a sealed bottom edge and a tight header seal moderates both.
Appearance rules matter too. Fairfax County's permit guide lists direct replacement of existing doors as work that needs no permit, but enlarging an opening or adding wiring is a different matter. Covenant communities, town historic districts and several county overlay districts review exterior changes, so we confirm the approved style before ordering.
Opening width and height, headroom, side room and back room all get measured, and the old door, track and opener are looked over.
Panel style, insulation, windows and color are chosen with you, and an exact price is given on site before any order is placed.
The old door comes out, and the new sections, tracks, hinges, rollers and seals go in on a matched hardware set.
Springs are sized to the final weight, the top section reinforced for the opener, and the balance and reversing system tested.



Tell us in a line what the door does — stalls halfway, slams down, hums without moving, sits crooked — and the Westwood office calls you back to fix a time. Starting prices sit on every service page; your own number is worked out at the garage.
Fill in the short form ☎ Call (571) 380-8377
The way we treat the details you type in is described in our privacy notice.