Vienna, VA · Open 7 AM to 10 PMCall: (571) 380-8377

Garage Door Cable Repair

The cables tie the bottom of the door to the drums; one frayed or slack cable and the door rides up crooked.

A frayed or snapped lift cable is replaced as part of a set, with the drums and bottom brackets checked in the same visit. Each cable runs from a bracket at the bottom corner of the door, up the side, and onto a drum on the spring shaft. As the door lowers, the cables unwind from the drums and the springs tighten, and as it rises the springs unwind and the cables wind back on, so these thin steel strands carry the lifting force on each side.

Industry safety guidance tells homeowners to look over the cables where they meet the bottom brackets and to leave replacement to a trained technician, because the brackets and cables sit under the full spring load. A cable that has snapped on one side leaves that corner dropping while the other side climbs, which jams the door in the track and often bends a roller or a section on the way down.

We replace both cables, since they have carried the same load for the same time. We also look at the drums for grooves worn into the cable seat, because a damaged drum frays the new cable early. After the swap the door is leveled and the springs' tension is checked against it.

Symptoms of a worn lift cable

  • One corner of the door hangs lower than the other
  • A cable lies loose on the floor or dangles beside the track
  • Strands are visibly fraying near the bottom bracket
  • The cable has jumped off its drum above the door
  • A slack cable shows on one side while the other stays tight
  • The door shakes or twists as it lifts

The Northern Virginia Freeze and Brine Factor

The lower end of a cable and its bottom bracket take the worst of a Virginia winter. Wet snow and road brine collect against the floor line, and the lower end of a steel cable is the first place rust gets into the strands. At about 102 days a year with a low at or below freezing at the Dulles airport station, that damp freezes and thaws against the metal again and again.

A door that sits closed in a damp garage for weeks also stays under constant load. We inspect the bottom bracket as closely as the cable, and we pick cable and fittings with a coating that holds up to salt.

How We Handle It

Step 1

Secure the door

The door is braced so it cannot drop, and the spring tension is released in a controlled way before a cable is touched.

Step 2

Inspect the whole path

Bottom brackets, drums, cable seats, rollers and tracks are read for the damage a snapped cable usually leaves behind.

Step 3

Replace the set

New cables on both sides, with drums or fittings replaced if they are worn, and the price quoted on site before we start.

Step 4

Level and test

The door is leveled, spring tension reset, and the travel cycled several times to prove the cables track evenly.

Cable jobs in pictures

Technician working at the torsion spring above the door opening
Technician at the spring shaft with old door parts laid on the floor
Technician kneeling on a rug in an open garage, working on a long door shaft

Garage Door Cable Repair — FAQs

Could a handy homeowner change a lift cable alone?
We advise against it. Trade safety guidance reserves cable replacement for trained technicians, since the bottom bracket and the cable hold the spring tension. One slip can injure a hand or let the door fall.
If one cable failed, does the other need changing as well?
Yes. Both cables have worked for the same number of cycles in the same conditions, so the second one is close behind. Replacing the set also keeps the two sides of the door even when it lifts.
Why do lift cables fray and break?
Fatigue and corrosion. Cables fray where they bend over the drum and rust near the bottom bracket, and a spring that is out of balance puts extra strain on one side. An impact on the door can also kink a cable and start the damage.
Why does one side of my garage door sit higher?
That usually means a cable has broken, slipped off the drum or stretched on that side. Stop using the opener, because forcing the door can bend the track. We level and restring it.
How much does garage door cable repair cost?
A cable job begins from $150 per cable. Drums, brackets and any damaged sections differ from door to door, so we state the exact quote on site before any work starts.
Where We Provide Garage Door Cable Repair

Garage Door Cable Repair Across Fairfax County

Westwood office · open 7 AM to 10 PM

Book a technician

Tell us in a line what the door does — stalls halfway, slams down, hums without moving, sits crooked — and the Westwood office calls you back to fix a time. Starting prices sit on every service page; your own number is worked out at the garage.

Fill in the short form ☎ Call (571) 380-8377

The way we treat the details you type in is described in our privacy notice.

☎